2 Bow Bimini Top Instructions
Fit Crossbars into Starboard Frame.
LAY FABRIC AS SHOWN (SLEEVES UP).
FEED THE CROSSBARS THROUGH FABRIC SLEEVES
(LONG UPRIGHT GOES THROUGH REAR SLEEVE)
COMPLETE BIMINI BY ATTACHING THE PORT FRAME TO CROSSBARS (AS IN STEP 1)
ATTACH WEBBING STRAPS TO BIMINI
ATTACHING THE BIMINI TO THE BOAT
1. Locate where the Bimini Deck Mounts will be placed. Measure and confirm the marks for the Deck Mounts to ensure they are exactly opposite each other. If Deck Mounts are not parallel, the Bimini will be unbalanced.
2. Drill and secure the Deck mounts using suitable hardware (not supplied).
Note: The taper on the Deck Mounts; ensure they lean inwards to match the Bimini frame. Place Bimini into deck mounts as shown. Secure tube ends with Self Tapping Screws.
3. POSITIONING THE SADDLES.
The distance between the Deck Mounts and Saddles depends on personal preference, however placement between 0.9m – 1.1m (35” – 43”) is recommended. Drill and secure the saddles using suitable hardware (not supplied).
4. Tighten and adjust webbing until even tension is achieved across bimini.
RELEASE THE SNAP HOOK
UNZIP PANEL ON THE REAR POCKET TO RELEASE STORAGE BOOT PANEL
FOLD THE BIMINI & PLACE THE WEBBING STRAPS ON THE TOP
FOLD PANEL OVER BIMINI TOP & WEBBING STRAPS